This is 5000 Gallon Stainless Steel Jet Refueler mounted on a 2005 International chassis.
Refueler Specifications as follows:
- 5000 Gallon Jet Refueler (plus 3% Expansion) Per NFPA 407 & 385
- Single Compartment Tank
- Stainless Steel Construction including Heads, Shell, Baffles and Sub-Frame
- Aluminum Rolled Fenders with Stainless Steel Fender Brackets
- 8" Channel Rear Bumper
- Ladder with Grab Handles in Module
- Two (2) 20" Manhole with 10" Fill DOT Venting, Self Latching with Pressure
Relief Valve
- Vents - Two (2) Clay & Bailey
- Chelsea Hot-shift Power Take-off with Heavy Duty Shaft & Flanged Yokes
- Pump - Gorman Rupp , #03H1-GR, 300 GPM
- Plumbing - 3" & 2" Stainless Steel
- Internal Valve - $: Thiem F-614A with F-613AD Jet Level Sensor for High
Level Shut-down
- Electric Deadman with 50' Deadman Cable
- By-Pass Valve - 3" for Secondary Control
- Filter/Separator - 300 GPM with Air Eliminator, Water Slug Float
- Differential Pressure Gauge, 30 PSI, Piston Type
- Manual Drain Valve
- Meter- 3", 300 GPM Liquid Controls M-25 with Large Numeral Counter, Reset &
Accumulator - Calibrated & Sealed for Turbine Fuel.
- Meter - 2", 150 GPM Liquid Controls M-10 with Large Numeral Counter, Reset
Shut-off Valves at Hose Reels and at Bottom Load Adapter, 3"
- Hose Reel -3" Electric Rewind, Explosion Proof Motor, Swing Joint Inlet
- Hose - 2" x 50' M&M Coupling , Tested & Certified
- Nozzle - Thiem, 2 1/2", F-116 with Strainer, Swivel and Disconnect
- Hose Reel - (2) Electric Rewind , Explosion Proof Motor, Swing Joint Inlet
- Hose - Two (2) 1 1/4" x 50' M&M Coupling, Tested & Certified
- Nozzle - Two (2) 1 1/4" OPW Overwing Nozzle #295SAJ
- Bottom Load Adapter, 2 1/2", Thiem
- Brake Interlock System - Nozzles, Pump and Bottom Load
- Tank Water Draw Valve - One at each end of tank
- One Fuel Pressure Gauge and One Nozzle Pressure Gauge installed on the
Control Panel
- Fire Extinguishers - Two (2) 20lb. BC with Truck mounting brackets
- Static Grounding Reel w/ 50' Cable
- All Valve and Control Labeled
- All Stainless Steel Parts - unpainted
- All Operating Decals - Installed
- Operating Instructions and Manufacturing Plate with Schematic
Options Available:
- Chassis- Cab (Per Customer Specification)
- Additive Injection system
- Rotating Beacon